SOFT, FREESTANDING GAP FILLER
G-filler™ 1000 V0 is a very soft, freestanding gap filler that is more compliant than most other
gap fillers. Combining good thermal conductivity of 1.1 W/mK with high conformability,
this gap filler produces low thermal resistance. The alumina filler allows the product to
remain a cost effective solution where moderate thermal performance is acceptable.
Naturally tacky and not requiring additional adhesive coating, the G-filler™ 1000 V0 can inhibit
thermal performance. This gap filler is both electrically insulating and stable from -40°C to
160°C and meets UL 94 VO rating.
FEATURES AND BENEFITS
• Soft and compressible for low stress applications
• Naturally tacky needing no further adhesive coating
• 1.1 W/mK thermal conductivity
• Available in thicknesses from 0.010” (0.25mm) to 0.1000” (5.0mm)
APPLICATIONS
• Cooling components to the chassis or frame
• High speed mass storage drives
• RDRAM memory modules
• Heat pipe thermal solutions
• Automotive engine control units
• Wireless communication hardware

STANDARD THICKNESSES
0.020" (0.51mm) 0.030" (0.76mm) 0.040" (1.02mm) 0.050" (1.27mm)
0.060" (1.52mm) 0.070" (1.78mm) 0.080" (2.03mm) 0.090" (2.29mm)
0.100" (2.54mm) 0.110" (2.79mm) 0.120" (3.05mm) 0.130" (3.30mm)
0.140" (3.56mm) 0.150" (3.81mm) 0.160" (4.06mm) 0.170" (4.32mm)
0.180" (4.57mm) 0.190" (4.83mm) 0.1000" (5.08mm)
Consult the factory for alternate thicknesses
THR-SPEC-G-FILLER-100V0 0409

STANDARD SHEET SIZES
9" x 9" (229mm x 229mm) G-filler™ 1000V0 may be die cut into
individual
shapes. Pressure sensitive adhesive is not applicable for G-filler™ products.

REINFORCEMENT
0.020" (0.51mm) and 0.030" (0.762mm) are fiberglass reinforced.

Data for design engineer guidance only. Observed performance varies in
application. Engineers are reminded to test the material in application.

THR-SPEC-G-FILLER-100V0 0409
Any information furnished by Laices Technologies and its agents is believed to be accurate and reliable. Responsibility for the use and application of Laices Technologies materials rests with
the end
user since Laices Technologies and its agents cannot be aware of all potential uses. Laices Technologies makes no warranties as to the fitness, merchantability, or suitability of any Laices
Technologies
materials or products for any specific or general uses. Laices Technologies shall not be liable for incidental or consequential damages of any kind. All Laices Technologies products are sold
pursuant to
the Laices Technologies domestic terms and conditions of sale in effect from time to time, a copy of which will be furnished upon request.damages of any kind. All Laices Technologies’
products are
sold pursuant to the Laices Technologies’ domestic terms and conditions of sale in effect from time to time, a copy of which will be furnished upon request. A14175-00 Rev. G, 08/13/08
® 10008 All Rights Reserved. Laices Technologies is a registered trademark of Laices Technologies, Inc.